Camera commands for Raspberry Pi.

• Enable UPnP online PORT Forwarding
  Enable live stream over internet.
  Set the 'streamport' camera config.
  UPnP must be enabled on your router.)
• Disable UPnP online PORT Forwarding
  Disable live stream over internet.
• Clear local queue
  Clear all the images on your camera's queue.
• Start local configuration webserver
  Start cameras configuration webserver on port 80, login with username and uploadkey.
• Stop local configuration webserver
  Stop cameras configuration webserver
• Send debug LOG
  Send a debug log to Motiondetection.be for investigation of problems.
• Fetch config
  Update your camera's config with the settings from Motiondetection.be
• Send cams
  Send camera's devices to Motiondetection.be
• Fetch WIFI
  Update camera's WIFI settings from Motiondetection.be
• Disable LED
  Disable your camera's built-in LED.
• Enable LED
  Enable your camera's built-in LED.
• Disable SOUND
  Disable your camera's internal sound to preserve USB bandwidth.
• Enable SOUND
  Enable your internal sound.
• Disable Bluetooth
  
• Enable Bluetooth
  
• Install object detection
  Install object detection to recognise and filter: people, cars, bicycle, pets,... (check first 'detectobjects' in camera config)
• UNInstall object detection
  
• Enable auto reboot on kernel panic
  Auto reboot when the system encounters errors. (eg: hardware failure, SD card failure,...)
• Disable auto reboot on kernel panic
  
• Stop
  Stop the internal camera
• Restart
  Restart the internal camera.
• Reboot
  Reboot your camera.
• UPGRADE
  Upgrade internal software.(WARNING: might break your camera!)
• FIRMWARE UPGRADE
  Upgrade the camera's firmware. (WARNING: might break your camera!)
• Shutdown
  Shutdown your camera. (WARNING: manual repower!)